correct/crimp tools: H53 / H53L

CS30L Handle Only

H53-D Die Short Barrel

H53L-D Die Long Barrel

· Traceability

· Hollingsworth CORRECT/CRIMP terminal tool leaves its mark on every terminal it crimps. Even after years of service, a connection can be verified as correctly crimped because each die imprints its size code into the connector during crimping.

· In ISO 9000 applications, and all other cases where documentation of correct performance is an important factor, CORRECT/CRIMP is the right tool – the only tool – for the job.

HOLLINGSWORTH INFORMATION:

The H53 replaces the H7B and the

H6E – 1 TOOL – 3 CAVITIES

H53 / h53l short / long barrel
Correct Crimp Tools

Interchangeable Dies

The H53 Short Barrel and H53L Long Barrel accommodates the dies shown below, plus many others. Consult the factory for a complete list.

	EG-701 § Crimps a variety of open barrel contacts in medium to large size wire ranges with one tool closure. Crimps are “B” type and are produced in three cavities: A 22-18 AWG, B 16-14 AWG or C 12-10 AWG
	EG-704 § Crimps non-insulated terminals and splices. Crimps are produced in three cavities: A 22-18 AWG, B 16-14 AWG or C 12-10 AWG
	EG-709 § Crimps conductor portion of heat shrink or insulated terminals. Crimps are produced in three cavities: RED 22-18 AWG, BLUE 16-14 AWG or YELLOW 12-10 AWG
	EG-750 § Crimps conductor and strain relief portion of insulated slide-on terminals in one tool closure. Crimps are produced in two cavities: RED 22-18 AWG or BLUE 16-14 AWG
	EG-756 § Crimps center pin to a .068 hex or .042 square, certain ferrules of fiber optic connectors to .100 or .178 hex, RG174 ferrule to a .178 hex, RG58 ferrule to a .213 hex, and RG59 ferrule to a .255 hex.
	EG-766 §